Sunday, October 11, 2020

Jeans repair, using a under-patch

 






Time for another jeans mend. 

My hubby came with his well-worn jeans, hoping to get them repaired. 



Even they had a lot of wear and very thin fabric, I thought they would last a while longer. 

Instead of using an over patch like last time, I went for a under patch this time. First, I cut a patch from some left-over fabric, making sure it would cover the entire worn area. 



Then securing the edges using my serger, you can use a regular sewing machine and zig-zag seam or scallop scissors. 

 Turning the jeans inside out to put the patch in place with pins. 




Then turning them again to start stitching. I put a quilting ruler inside the leg, to make sure I didn’t stitch through the back side of the leg. A good tip I got from Tricia, @morrissews




Earlier I have used a small book, or a small chopping board. 

 

 Sashiko does look good on jeans. Now I’m not very good on following rules so I keep to sashiko inspired. 



Here it’s only running stitches.  Making a different pattern this time.  



When done in one direction, stitching in the other direction, making a stitch from one of the previous stitches to the next. Then under the next.  Keep this up until you reach the end the. In the next row, you make sure your top stitch is in the same place as in the previous row. If you are more accurate than me you will have nice squared boxes. Keep it up until you have done all stitches. 



Now my hubby’s jeans just need the other leg repaird ,but  your jeans are ready to wear again. 





This pair of jeans had a hole in the butt too.  



It’s darned using thick sewing thread and some variegated embroidery thread. 



You can learn how to darn in our post about Sock darning.  



 

No comments:

Post a Comment

Wool jacket repair

  I was asked if I could mend this double wool jacket. At first the owner only thought it was a few holes in the sleeves but discovered a bi...